Instructions

Please read the following instructions before you start to apply your vinyl transfer(s).

You’re going to need:

• Methylated Spirits

• 2 pieces of lint-free cloth

• Masking tape

• Application Squeegee

Step 1: Cleaning

Remove the graphics from their packaging.

Only work in a clean environment and out of the elements. Clean the surface with methylated spirits to remove any residue.

Step 2: Positioning

Tape the graphic in place using masking tape, once you are happy with the positioning of the transfer, proceed to step 3. You can also use masking tape to create a baseline to help keep the transfer straight.

Step 3: Remove Backing

With the transfer held in place with the masking tape, remove half of the backing and lightly apply to the surface. Use the squeegee to work any air bubbles from the centre to the edge of the transfer. Then use the same method to apply the remaining half of the transfer.

Step 4: Remove Application Tape

Lift from a corner and make sure nothing is lifting off. If it does, stop pulling back the application tape and firmly press the transfer back down and wait an hour or 2 before continuing.